Table of Contents
Advertisement
2) Remove the duplexing driver PCB [1].
- 2 screws [2]
3.2.15 Low-Voltage Power Supply Assembly
3.2.15.1 Preparation for Removing the Low-Voltage
Power Supply PCB
LBP5100
1) Remove the delivery tray. (page 3-7)Reference [Removing the Delivery
Tray]
2) Detach the rear cover. (page 3-2)Reference [Removing the Rear Cover]
3) Detach the right cover. (page 3-2)Reference [Removing the Right Cover
/ Right Cassette Cover]
4) Detach the upper cover. (page 3-5)Reference [Removing the Upper
Cover]
5) Detach the left cover. (page 3-4)Reference [Removing the Left Cover /
Left Cassette Cover]
6) Remove the high-voltage power supply PCB. (page 3-19)Reference
[Removing the High-Voltage Power Supply PCB]
7) Detach the face-down cover. (page 3-7)Reference [Removing the Face-
Down Cover]
8) Remove the duplexing drive assembly. (page
[Removing the Duplexing Drive Assembly]
3.2.15.2 Removing the Low-Voltage Power Supply PCB
LBP5100
1) Detach the upper rear metal sheet [1].
- 4 screws [2]
2) Disconnect the 9 connectors [1], and then disengage the cables from the
cable guide.
F-3-112
F-3-113
3-12)Reference
F-3-114
3) Disengage the cable guide [1].
- 2 claws [2]
4) Slide the cable guide [1] to the left, and then detach the cable guide.
0015-7573
5) Disconnect the 3 connectors [1].
0015-7574
6) Remove the cable.
- 2 wire saddles [1]
- 1 reuse band [2]
7) Disengage the cable from the cable guide [1].
Chapter 3
F-3-115
F-3-116
F-3-117
F-3-118
F-3-119
3-17
Advertisement
Table of Contents
