White Indicator Lights - Jeep GRAND CHEROKEE WK 2022 Owner's Manual

86 GETTING TO KNOW YOUR INSTRUMENT PANEL
Sport Mode Indicator Light
This light will turn on when Sport Mode is
active Ú page 100.
Stop/Start Active Indicator Light —
If Equipped
This indicator light will illuminate when
the Stop/Start function is in "Autostop"
mode Ú page 107.
Turn Signal Indicator Lights
When the left or right turn signal is
activated, the turn signal indicator will
flash independently and the
corresponding exterior turn signal lamps
will flash. Turn signals can be activated when the
multifunction lever is moved down (left) or up
(right).
NOTE:
A continuous chime will sound if the vehicle is

driven more than 1 mile (1.6 km) with either
turn signal on.
Check for an inoperative outside light bulb if

either indicator flashes at a rapid rate.
W I L
HITE NDICATOR IGHTS
Adaptive Cruise Control (ACC) Ready Light —
If Equipped
This light will turn on when the vehicle
equipped with ACC has been turned on,
but not set Ú page 111.
Cruise Control Ready Indicator Light
This light will turn on when the cruise
control has been turned on, but not set
Ú page 109.
Hill Descent Control (HDC) Indicator Light —
If Equipped
This indicator shows when the HDC
feature is turned on. The lamp will be on
solid when HDC is armed. HDC can only
be armed when the transfer case is in the
4WD Low position and the vehicle speed is less
then 30 mph (48 km/h). If these conditions are not
met while attempting to use the HDC feature, the
HDC indicator light will flash on/off.
LaneSense Indicator Light — If Equipped
When the LaneSense system is ON, but
not armed, the LaneSense indicator light
illuminates solid white. This occurs when
only left, right, or neither lane line has
been detected. If a single lane line is detected, the
system is ready to provide only visual warnings if
an unintentional lane departure occurs on the
detected lane line Ú page 129.
Selec-Speed Control Indicator Light —
If Equipped
This light will turn on when "Selec-Speed
Control" is activated.
To activate "Selec-Speed Control",
assure the vehicle is Four Wheel Drive (4WD) Low
and push the button on the Instrument Panel.
NOTE:
If the vehicle is not in 4WD Low, "To Enter
Selec-Speed Shift to 4WD Low" will appear in the
instrument cluster display.