Trip Computer - Jeep GRAND CHEROKEE WK 2022 Owner's Manual

78 GETTING TO KNOW YOUR INSTRUMENT PANEL
Loss of the battery charge may indicate one or
more of the following conditions:
The charging system cannot deliver enough

electrical power to the vehicle system because
the electrical loads are larger than the capability
of charging system. The charging system is still
functioning properly.
Turning on all possible vehicle electrical loads

(e.g. HVAC to max settings, exterior and interior
lights, overloaded power outlets +12 Volts,
150W, USB ports) during certain driving condi-
tions (city driving, towing, frequent stopping).
Installing options like additional lights, upfitter

electrical accessories, audio systems, alarms
and similar devices.
Unusual driving cycles (short trips separated by

long parking periods).
The vehicle was parked for an extended period

of time (weeks, months).
The battery was recently replaced and was not

charged completely.
The battery was discharged by an electrical load

left on when the vehicle was parked.
The battery was used for an extended period

with the engine not running to supply radio,
lights, chargers, +12 Volt portable appliances
like vacuum cleaner's, game consoles and
similar devices.
What to do when an electrical load reduction
action message is present ("Battery Saver On" or
"Battery Saver Mode")
During a trip:
Reduce power to unnecessary loads if possible:

Turn off redundant lights (interior or exte-

rior)
Check what may be plugged in to power

outlets +12 Volts, 150W, USB ports
Check HVAC settings (blower, temperature)

Check the audio settings (volume)

After a trip:
Check if any aftermarket equipment was

installed (additional lights, upfitter electrical
accessories, audio systems, alarms) and review
specifications if any (load and Ignition Off Draw
currents).
Evaluate the latest driving cycles (distance,

driving time and parking time).
The vehicle should have service performed if

the message is still present during consecutive
trips and the evaluation of the vehicle and
driving pattern did not help to identify the cause.

TRIP COMPUTER

Push and release the up or down
button until the Trip icon shows in the instrument
cluster display (Toggle left or right
Trip A or Trip B).
Trip A/Trip B
Shows the total distance traveled for Trip A/Trip

B since the last reset.
Shows the elapsed time traveled for Trip A/Trip

B since the last reset.
Shows average fuel consumption for Trip A/Trip

B since the last reset.
Elapsed time will increment when the ignition

switch is in the ON or START position.
To Reset Trip A/B Function
Reset will only occur while a function is selected.
Push and hold the OK button to reset/clear the
function being displayed.
arrow
to select