Parallel/Perpendicular Parking Space Assistance Operation - Jeep GRAND CHEROKEE WK 2022 Owner's Manual

126 STARTING AND OPERATING
Driver's door is opened

Rear liftgate is opened

Electronic Stability Control/Anti-Lock Braking

System intervention
4WD Low is active or activated

SAND mode (if equipped) is active or activated

MUD mode (if equipped) is active or activated

The ParkSense Active Park Assist system allows a
maximum number of shifts between DRIVE and
REVERSE. If the maneuver cannot be completed
within the maximum amount of shifts, the system
will cancel and the instrument cluster display will
instruct the driver to complete the maneuver
manually.
NOTE:
The number of shifts will vary between two move-
ments (for large parking spots) and eight move-
ments (for small parking spots).
The ParkSense Active Park Assist system will only
operate and search for a parking space when the
following conditions are present:
Gear selector is in DRIVE

Ignition is in the RUN position

ParkSense Active Park Assist switch is activated

Driver's door is closed

Rear liftgate is closed

Vehicle speed is less than 15 mph (25 km/h)

NOTE:
If the vehicle is driven above approximately
15 mph (25 km/h), the instrument cluster display
will instruct the driver to slow down. If the vehicle
is driven above approximately 18 mph (30 km/h),
the system will cancel. The driver must then reac-
tivate the system by pushing the ParkSense Active
Park Assist switch.
The outer surface and the underside of the front

and rear fascias/bumpers are clean and clear
of snow, ice, mud, dirt or other obstruction.
When pushed, the LED on the ParkSense Active
Park Assist switch will blink momentarily, and then
the LED will turn off if any of the preceding
conditions are not present.
P /P
ARALLEL ERPENDICULAR
S A O
PACE SSISTANCE PERATION
When the ParkSense Active Park Assist system is
enabled, the "Active ParkSense Searching - Press
OK to Switch to Perpendicular" message will
appear in the instrument cluster display. Push the
OK button on the left side of the steering wheel to
change your parking space setting to a
perpendicular maneuver. You may switch back to
parallel parking if you desire.
Switch To Perpendicular
Once the driver pushes OK for a perpendicular
parking maneuver, the "Active ParkSense
Searching - Press OK to switch to Parallel"
message will appear in the instrument cluster
P
display.
ARKING
Switch To Parallel