White Indicator Lights - Jeep CHEROKEE 2023 Owner's Manual

74 GETTING TO KNOW YOUR INSTRUMENT PANEL
Adaptive Cruise Control (ACC) Set Without
Target Vehicle Indicator Light —
If Equipped
This will display the distance setting for the ACC
system when the system is engaged
page 92.
Ú
Cruise Control Set Indicator Light —
If Equipped
This indicator light will illuminate when the
cruise control is set to the desired speed
page 90.
Ú
Front Fog Indicator Light —
If Equipped
This indicator light will illuminate when the
front fog lights are on page 39.
Ú
LaneSense Indicator Light —
If Equipped
The LaneSense indicator light illuminates solid
green when both lane markings have been
detected and the system is "armed" and ready
to provide visual and torque warnings if an
unintentional lane departure occurs
Ú
Parking/Headlights On Indicator Light
This indicator light will illuminate when the
parking lights or headlights are turned on
page 39.
Ú
Stop/Start Active Indicator Light
This telltale will illuminate when the Stop/Start
function is in "Autostop" mode.
Turn Signal Indicator Lights
When the left or right turn signal is activated,
the turn signal indicator will flash
independently and the corresponding exterior
turn signal lamps will flash. Turn signals can be
activated when the multifunction lever is moved down
(left) or up (right).
NOTE:
 A continuous chime will sound if the vehicle is driven
more than 1 mile (1.6 km) with either turn signal on.
 Check for an inoperative outside light bulb if either indi-
cator flashes at a rapid rate.
W I
HITE NDICATOR
Active Speed Limiter Ready Indicator
Light — If Equipped
page 109.
This light will turn on when the Active Speed
Limiter is on, but not set.
Hill Descent Control (HDC) Indicator
Light — If Equipped
Low position and the vehicle speed is less then 30 mph
(48 km/h). If these conditions are not met while
attempting to use the HDC feature, the HDC indicator light
will flash on/off.
LaneSense Indicator Light — If Equipped
detected. If a single lane line is detected, the system is
ready to provide only visual warnings if an unintentional
lane departure occurs on the detected lane line
page 109.
Ú
Selec-Speed Control Indicator Light —
If Equipped
L
IGHTS
NOTE:
If the vehicle is not in 4WD Low, "To Enter Selec-Speed
Shift to 4WD Low" will appear in the instrument cluster
display.
This indicator shows when the Hill Descent
Control (HDC) feature is turned on. The light will
be on solid when HDC is armed. HDC can only
be armed when the transfer case is in the 4WD
When the LaneSense system is ON, but not
armed, the LaneSense indicator light
illuminates solid white. This occurs when only
left, right, or neither lane line has been
This light will turn on when "Selec-Speed
Control" is activated.
To activate "Selec-Speed Control", ensure the
vehicle is in Four-Wheel Drive (4WD) Low and
push the button on the Instrument Panel.