Instrument Cluster Display Messages; Operation - Jeep GRAND CHEROKEE WK 2022 Owner's Manual

Wheel Alignment Mode
Before performing a wheel alignment this mode
must be enabled Ú page 152.
NOTE:
This mode is intended to be enabled with the
engine running.
If equipped with a touchscreen radio all enabling/
disabling of air suspension features must be done
through the radio Ú page 152.
I C D
NSTRUMENT LUSTER ISPLAY
M
ESSAGES
When the appropriate conditions exist, a message
will appear in the instrument cluster Ú page 73.
O
PERATION
The indicator lamps 2 through 5 will illuminate to
show the current position of the vehicle. Flashing
indicator lamps will show a position which the
system is working to achieve. When raising, if
multiple indicator lamps are flashing on the UP
button, the highest flashing indicator lamp is the
position the system is working to achieve. When
lowering, if multiple indicators are flashing on the
DOWN button the lowest solid indicator lamp is the
position the system is working to achieve.
Pushing the UP button once will move the
suspension one position higher from the current
position, assuming all conditions are met (i.e.
engine running, speed below threshold, etc). The
UP button can be pushed multiple times. Each
push will raise the requested level by one position
up to a maximum position of OR2 or the highest
position allowed based on current conditions (i.e.
vehicle speed, etc).
Pushing the DOWN button once will move the
suspension one position lower from the current
level, assuming all conditions are met (i.e. engine
running, doors closed, speed below threshold, etc).
The DOWN button can be pressed multiple times.
Each push will lower the requested level by one
position down to a minimum of Entry/Exit Height or
the lowest position allowed based on current
conditions (i.e. vehicle speed, etc.)
STARTING AND OPERATING
Automatic height changes will occur based on
vehicle speed and the current vehicle height. The
indicator lamps and instrument cluster display
messages will operate the same for automatic
changes and user requested changes.
Off-Road 2 (OR2) – Indicator lamps 2, 3, and 4

will be illuminated.
Off-Road 1 (OR1) – Indicator lamps 3 and 4 will

be illuminated.
Normal Ride Height (NRH) – Indicator lamp 4

will be illuminated.
Entry/Exit Height – Indicator lamp 5 will be illu-

minated.
Transport Mode – No indicator lamps will be illu-

minated. Driving will disable Transport Mode.
Tire/Jack Mode – Indicator lamps 2 and 5 will

be illuminated. Driving will disable Tire/Jack
Mode.
Wheel Alignment Mode – Indicator lamps 4 and

5 will be illuminated. Driving will disable Wheel
Alignment Mode.
105
4