Jeep GRAND CHEROKEE WK 2022 Owner's Manual page 17

All doors can be programmed to unlock on the first
push of the unlock button through Uconnect
Settings Ú page 152.
Key Left Vehicle Feature
If a valid key fob is no longer detected inside the
vehicle while the vehicle's ignition system is in the
ON/RUN or START position, the message "Key Fob
Has Left The Vehicle" will be shown in the
instrument cluster display along with an interior
chime. An exterior audible and visual alert will also
be activated to warn the driver.
The vehicle's horn will rapidly chirp three times
along with a single flash of the vehicle's exterior
lights.
NOTE:
The doors have to be open and then closed in

order for the vehicle to detect a key fob; the Key
Left Vehicle feature will not activate until all of
the doors are closed.
These alerts will not be activated in situations

where the vehicle's engine is left running with
the key fob inside.
Replacing The Battery In The Key Fob
The recommended replacement battery is one
CR2032 battery.
NOTE:
Customers are recommended to use a battery

obtained from Mopar®. Aftermarket coin
battery dimensions may not meet the original
OEM coin battery dimensions.
Perchlorate Material — special handling may

www.dtsc.ca.gov/hazard-
apply. See
ouswaste/perchlorate
for further information.
Do not touch the battery terminals that are on

the back housing or the printed circuit board.
1. Remove the emergency key (2) by sliding the
emergency key release (1) on the back of the
key fob and pulling the emergency key out
with your other hand.
Emergency Key Removal
1 — Emergency Key Release
2 — Emergency Key
GETTING TO KNOW YOUR VEHICLE
2. Separate the key fob halves using a #2 flat
blade screwdriver or a coin, and gently pry the
two halves of the key fob apart. Make sure not
to damage the seal during removal.
Separating Case With A Coin
Key Fob Battery Replacement
15
2