Ap Select Screen - ZyXEL Communications WAP3205 User Manual

Table 28 Network > Wireless LAN > Scheduling (continued)
L ABEL
Except for the
following times
Apply
Reset
6.10 AP Se le c t Sc re e n
Use this screen to choose an access point that you want the WAP3205 v3 (in universal repeater mode)
to connect to. You should know the security settings of the target AP.
To open this screen, click
Network > Wireless LAN > AP Select
Fig ure 43
The following table describes the labels in this screen.
Table 29 Network > Wireless LAN > AP Select
L ABEL
AP Select
First
Previous
Next
Last
Chapter 6 Wireless LAN
DESC RIPT IO N
Select a begin time using the first set of
end time using the second set of
earlier for the WLAN Status the Wireless LAN will turn off between the two times you enter in
O n
these fields. If you have chosen
between the two times you enter in these fields.
Note: Entering the same begin time and end time will mean the whole day.
Click to save your changes back to the WAP3205 v3.
Apply
Click to reload the previous configuration for this screen.
Re se t
>
Ne two rk Wire le ss L AN
DESC RIPT IO N
Click button to go to the first page of the AP select table.
First
Click button to go to the previous page in the AP select table.
Pre vio us
Click button to go to the next page in the AP select table.
Ne xt
Click button to go to the last page of the AP select table.
L a st
WAP3205 v3 User's Guide
and minute (
ho ur
and minute (
ho ur m in
earlier for the WLAN Status the Wireless LAN will turn on
O ff
> tab.
AP Se le c t
66
) drop down boxes and select an
m in
) drop down boxes. If you have chosen