Connection Wizard - Access Point Mode; Wlan Setup - ZyXEL Communications WAP3205 User Manual

Wizard Setup - General> System Operation Mode
Fig ure 8
The following table describes the labels in this screen.
Table 3 Wizard Setup - General> System Operation Mode
L A BEL
Access Point
Universal Repeater
Client Bridge
Apply
Reset
Note: After choosing an operating mode, the next screen will vary according to the mode
you have selected. If you have selected an operating mode different than the current
mode, your WAP3205 v3 will restart.
3.4 C o nne c tio n Wiza rd - Ac c e ss Po int Mo de
The WAP3205 v3's system operation mode is set to access point mode by default. In this mode your
WAP3205 v3 bridges a wired network (LAN) and wireless LAN (WLAN) in the same subnet.
3.4.1 WL AN Se tup
The following screen will open. Use this screen to configure the WAP3205 v3's wireless network settings.
Connection Wizard - Access Point Mode> WLAN Setup
Fig ure 9
Chapter 3 Connection Wizard
DESC RIPT IO N
Select to allow wireless devices to communicate with a wired
Ac c e ss Po int
network.
Select
Unive rsa l Re pe a te r
Select to connect your WAP3205 v3 to an existing network via an
C lie nt Bridg e
access point.
Click to save the changes to your WAP3205 v3.
Apply
Click to reload the previous configuration of this screen.
Re se t
WAP3205 v3 User's Guide
22
to transmit traffic between two wireless networks.