Ap Select Screen - ZyXEL Communications wap3205 V3 User Manual

Table 27 Network > Wireless LAN > Scheduling (continued)
LABEL
Except for the
following times
Apply
Reset

6.10 AP Select Screen

Use this screen to choose an access point that you want the WAP3205 v3 (in universal repeater mode)
to connect to. You should know the security settings of the target AP.
To open this screen, click Network > Wireless LAN > AP Select tab.
Figure 46 Network > Wireless LAN > AP Select
The following table describes the labels in this screen.
Table 28 Network > Wireless LAN > AP Select
LABEL
AP Select
First
Previous
Next
Last
Chapter 6 Wireless LAN
DESCRIPTION
Select a begin time using the first set of hour and minute (min) drop down boxes and select an
end time using the second set of hour and minute (min) drop down boxes. If you have chosen
On earlier for the WLAN Status the Wireless LAN will turn off between the two times you enter in
these fields. If you have chosen Off earlier for the WLAN Status the Wireless LAN will turn on
between the two times you enter in these fields.
Note: Entering the same begin time and end time will mean the whole day.
Click Apply to save your changes back to the WAP3205 v3.
Click Reset to reload the previous configuration for this screen.
DESCRIPTION
Click First button to go to the first page of the AP select table.
Click Previous button to go to the previous page in the AP select table.
Click Next button to go to the next page in the AP select table.
Click Last button to go to the last page of the AP select table.
WAP3205 v3 User's Guide
65