Chapter 3 Access Point Mode
3.3 What You Need to Know
See
Chapter 8 on page 59
point.
3.3.1 Setting your WAP3205 v2 to AP Mode
To use your WAP3205 v2 as an access point, see
1
Connect your computer to the LAN port of the WAP3205 v2.
2
The default IP address of the WAP3205 v2 is "192.168.1.2". In this case, your computer must have
3
an IP address in the range between "192.168.1.3" and "192.168.1.254".
Click Start > Run on your computer in Windows. Type "cmd" in the dialog box. Enter "ipconfig" to
4
show your computer's IP address. If your computer's IP address is not in the correct range then see
Appendix C on page 139
After you've set your computer's IP address, open a web browser such as Internet Explorer and
5
type "http://192.168.1.2" as the web address in your web browser.
Enter "1234" (default) as the password and click Login.
6
Type a new password and retype it to confirm, then click Apply. Otherwise, click Ignore.
7
3.3.2 Configuring your WLAN, LAN and Maintenance Settings
• See
Chapter 10 on page 83
wireless network and LAN settings.
• See
Chapter 12 on page 105
3.4 AP Mode Status Screen
Click
to open the Status screen.
18
for a tutorial on setting up a network with the WAP3205 v2 as an access
for information on changing your computer's IP address.
and
Chapter 11 on page 101
for information on configuring your Maintenance settings.
Section 2.1.1.1 on page
for information on the configuring your
16.
WAP3205 v2 User's Guide