List Of Equipment In The Expansion Kit; How To Install; Table 15-4 Equipment In Expansion Kit - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

List of Equipment in the Expansion Kit

List of Equipment in the Expansion Kit
When ordering an additional Site Controller, the following is included in the expansion kit.

Table 15-4 Equipment in Expansion Kit

Kit number
GMCN4729A

How to Install

This section described how to install and configure an additional Site Controller, gaining
Redundant Site Controller functionality.
15-26
Redundant Site Controller feature is supported on releases:
• R6.0_001.12, MTS 05
• R5.2_002.34, MTS 10
and later.
Description
Site Controller hardware kit
You must be familiar with Man-Machine Interface (MMI) commands and their
usage prior to performing procedures in this chapter. Improperly applying
MMI commands can result in equipment damage.
You must disable Black Ice or any other Firewall application before attempting to transfer files.
The MTS Site Controller has the following modes of operation:
• BOOT1 - to access this mode interrupt the booting process by pressing Escape
key or Control+C combination when appropriate message is shown. A
password may be required to enter this mode.
• Test Application - to access this mode enter the testapp command when in BOOT1
mode. To go back to normal Site Controller Application enter reset -oplatform
command to reboot and resume normal operation.
• Site Controller Application - if the boot process is not interrupted, this
is the default mode of operation.
Chapter 15: Expansion Options
6802800U74-N September 2009