Figure 5-20 Holes In Top Lid For Rx Cables; Table 5-22 Tx Atcc Phasing Harness Part Numbers - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual

Figure 5-20 Holes in Top Lid for Rx Cables

Table 5-22 TX ATCC Phasing Harness Part Numbers

Part Number
0166502N09
0166502N10
0166502N11
0166502N12
0166502N13
0166502N14
0166502N15
0166502N16
0166502N17
0166502N18
0166502N19
6802800U74-N September 2009
In the Prime Cabinet, detach the Duplexer Tx cable in the prime cabinet from the T connector
on the Interconnect Harness in the prime. Connect the free end of the Phasing Harness
from the expansion cabinet to the T connector on the Interconnect Harness in the prime
cabinet and connect the Duplexer Tx cable to the T connector in the Phasing Harness.
This way all eight channels are connected to a single Duplexer.
When Manual Tune Cavity Combiner (MTCC) is used instead of Auto Tune Cavity Combiner
(ATCC), connect the cables to corresponding inputs and outputs.
RX cables from Filters in Prime Cabinet to RX Splitters in the Expansion Cabinet
are routed through holes on the back side of the top-lid.
Description
Phasing harness, 8Ch
Phasing harness, 8Ch
Phasing harness, 8Ch
Phasing harness, 8Ch
Phasing harness, 8Ch
Phasing harness, 8Ch
Phasing harness, 8Ch
Phasing harness, 8Ch
Phasing harness, 8Ch
Phasing harness, 8Ch
Phasing harness, 8Ch
Frequency Band
361 MHz – 366 MHz
363 MHz – 368 MHz
382 MHz – 387 MHz
384 MHz – 389 MHz
390 MHz – 395 MHz
392 MHz.5-397.5 MHz
395 MHz – 400 MHz
420 MHz – 425 MHz
422.5 MHz – 427.5 MHz
425 MHz – 430 MHz
460 MHz – 465 MHz
RF Cabling
5-41