Other Can Bus Commands; Site Controller Configuration And Verification - Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual

Other CAN Bus Commands

Other CAN Bus Commands
Other CAN Bus Commands for mapping Track IDs are described in the appropriate
chapters as a part of a replacement procedure.:
can check_mapping lists the registered, unregistered and unknown devices connected through CAN Bus.
Example:
SC> can check_mapping
Units are present:
Device Track ID
DPM 1 JTH0500101
PSU 1 JTH0500200
Units are not present:
DPM 2 JTH0500105
Track ID not mapped
JTH0500102
•
•
Site Controller Configuration and Verification
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
The Site controller (SC) setup and checkout procedures specify steps that verify operation within
the Site Controller. The Site Controller verification consists of:
Process 6-2 The Site controller (SC) setup and checkout procedures.
1
2
3
6-10
If there are no devices present, this means the cabling is possibly corrupted.
All devices should be mapped.
not mapped
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
"Site Controller Setup" - Describes how to verify the Site Controller Configuration
"E1 Connection Test" "X.21 Connection Test"
to test E1 (X.21) interface and cabling
"Site Reference Check" - Describes how to check for proper SRI functioning.
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
- Describes how to perform E1 (X.21) Loopback
Chapter 6: Configuration and Testing
■ ■ ■ ■
■
■
6802800U74-N September 2009