Table of Contents
Advertisement
MTS 2 and MTS 4 Installation, Configuration and Basic Service Manual
MTS - Refreshing Ki's for the MTS
Procedure 8-15 MTS - How to Refresh Ki's for the MTS
On AuC open AuC Client and select Devices tab.
1
Find the relevant zone and site, select to highlight it. This shows that the CCK, AuC and Zone
2
KEK as not current.
Right-click the site and select Refresh Ki.
3
Result: The following message box appears:
KVL and then proceed to refresh site controller 1 and 2 for this site.
Subsequently ACK information...
Click OK.
4
Continue to
5
MTS - Connecting KVL to the AuC
Procedure 8-16 MTS - How to Connect KVL to the AuC
Verify that the AuC and KVL both have the correct baud rate setting. When connecting either
1
locally or remotely ensure that it is set for 19200. When connecting remotely the GSM cell
phone will only negotiate at 9600 but the KVL will auto negotiate the link speed.
Check the baud rate of the KVL login to the KVL, scroll until CONFIG is displayed on the screen.
2
Select CONFIG then scroll until BAUDR is displayed. Select BAUDR and change to 19200.
If this is the first time the KVL has been connected to a Zone then CLEAR LIST in the KVL to
3
ensure that there will be no cross contamination of Zone receipts and that the receipt list is empty
and therefore capable of receiving more Ki's:
Once the LIST is cleared you can connect the KVL to the AuC using either local or remote
4
connectivity.
Depending on method you want to use, continue to:
5
6802800U74-N September 2009
"MTS - Connecting KVL to the AuC" on page 8-35
• Log into the KVL at admin level.
• Select LIST from the display and then CLEAR.
• You are prompted for verification.
"MTS - Downloading Ki's from the AuC to KVL (Locally)" on page 8-36
•
"MTS - Downloading Ki's from the AuC to KVL (Remotely Using GSM)" on page 8-36
•
MTS - Refreshing Ki's for the MTS
Operator must now upload the Ki to a
to connect KVL to AuC.
8-35
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
