Motorola DIMETRA MTS 2 Installation, Configuration And Basic Service Manual page 390

Base Radio Alarms
Table 13-7 Generic Base Radio Alarms (Continued)
Alarm ID
ALM_BRC_ABACUS_FS3_ALM
ALM_BRC_ABACUS_FS3_FAIL
ALM_RX_3_3_VOLT_FAULT
ALM_RX_DC_3_3V_FAIL
ALM_RX_5_VOLT
ALM_RX_DC_5V_FAIL
ALM_RX_12_VOLT
ALM_RX_DC_12V_FAIL
ALM_RX_27_VOLT_FAULT
ALM_RX_DC_27V_FAIL
13-24
Recovery
Description
Action
Abacus frame BRC is de-keyed
sync 3 is by the software.
not present -
the alarm is
reported as a
fault indication
message from
DSP.
The same as ALM_BRC_ABACUS_FS3_ALM
Receiver DC Receiver is
3.3V line disabled by
failure. the software -
BRC is unable to
receive.
The same as ALM_RX_3_3_VOLT_FAULT
Receiver DC 5V Receiver is
line failure. disabled by
the software -
BRC is unable to
receive.
The same as ALM_RX_5_VOLT
Receiver DC Receiver is
12V line failure. disabled by
the software -
BRC is unable to
receive.
The same as ALM_RX_12_VOLT
Receiver DC Receiver is
27V line failure. disabled by
the software -
BRC is unable to
receive.
The same as ALM_RX_27_VOLT_FAULT
Chapter 13: MTS Troubleshooting
Clear Action
The alarm is The alarm may be
cleared just after reported because of
BRC is de-keyed. the BRC hardware
failure.
If the alarm The alarm may be
condition reported because
disappears then of some power
Receiver is supply problems
re-enabled by (cables, connectors)
the software. or the BRC hardware
failure / configuration
problem.
If the alarm The alarm may be
condition reported because
disappears then of some power
Receiver is supply problems
re-enabled by (cables, connectors)
the software. or the BRC hardware
failure / configuration
problem.
If the alarm The alarm may be
condition reported because
disappears then of some power
Receiver is supply problems
re-enabled by (cables, connectors)
the software. or the BRC hardware
failure / configuration
problem.
If the alarm The alarm may be
condition reported because
disappears then of some power
Receiver is supply problems
re-enabled by (cables, connectors)
the software. or the BRC hardware
failure / configuration
problem.
6802800U74-N September 2009
Notes