Installation Of Ms-Windows; Demonstration Installation - Casio IT-2000W Technical Reference Manual

5.2 Installation of MS-Windows

As explained on the previous page, it is necessary to move (copy) some files onto the write-permit
drive before booting MS-Windows. This section will describe this copy operation The following is
an example of manually installing necessary files so that the user can determine the contents.
A utility program (WINST.EXE) can be used to reduce the work load.
For more information about this installation utility refer to Chapter 9.10 "Windows Installation
Utility".

5.2.1 Demonstration Installation

For this terminal it is recommended to initiate the application program at the same time
MS-Windows is started. The program manager can also be initiated during the development of
application programs or for the purpose of demonstration. To initiate the program manager for the
above purpose use the following procedure:


Create the D:


Copy the entire content of E:
The following files are to be copied:
WIN.COM
WIN.CLN
SYSTEM.INI
PROGMAN.INI
CONTROL.INI
ACCESSOR.GRP
WINVER.EXE
SHARES.PWL


Create the CONFIG.SYS and AUTOEXEC.BAT files. Remember to add "D:

E: WINDOWS" to the existing path. Then specify "win.com" to boot MS-Windows at the end
of the AUTOEXEC.BAT file.


Copy the created CONFIG.SYS and AUTOEXEC.BAT files onto D:
The above procedures complete the demonstration installation of MS-Windows. MS-Windows will
be automatically booted if the terminal is re-started by pressing the RESET switch.

WINDOWS directory.

WINDOWS

LOCAL onto the created directory.
WIN.INI
WFWSYS.CFG
MOUSE.INI
SERIALNO.INI
MAIN.GRP
STARTUP.GRP
SYSTEM.CLN
85

WINDOWS;

.