Casio IT-2000W Technical Reference Manual page 255

List of termination codes
The following table shows the termination codes returned by FLINK.DLL. Note that only the
termination code (i.e. with no message) will be displayed at a termination.
End Code
Category Detail Code
(High) (LOW)
Normal end
00h
0DCh - 0F5h
F6h
F7h
F8h
File Error
(int21h)
02h
02h
02h
02h
02h
02h
02h
There may be cases where codes not defined as File Error (int21h) are returned. If this happens the
code is returned as a DOS expansion error code.
File Error
(int24h)
03h
03h
03h
03h
03h
03h
03h
03h
03h
03h
03h
03h
03h
03h
03h
00h Normal end.
00h Drive (A to Z) format notice.
00h Power off ending notice.
00h Reset ending notice.
00h Break key interrupt ending.
02h File not found.
03h Path not found.
0Bh Invalid format.
0Fh Invalid disk drive.
10h Delete request is current directory.
11h Not same disk.
12h Not same disk.
13h Write protect error.
14h Unknown unit.
15h Drive not ready.
17h Data error (CRC).
19h Seek error.
1Ah Unknown disk format.
1Bh Sector not found.
1Dh Write error.
1Eh Read error.
1Fh Unknown error.
20h File share error.
21h File lock error.
22h
23h
53h
255
Description