Casio IT-2000W Technical Reference Manual page 287

Keyboard=Setting Specifies the keyboard to be used. From the Setting column of the table
shown below select a value to be placed on the right side of the equation.
Belgian
British
Danish
Finnish
French Canadian
Icelandic
Latin American
Portuguese
Swedish
Swiss German
US-Dvorak
[Update] section This section will be referenced from the [Setup] section if
"UpdateDrivers=yes" is specified.
UpdateSysCall= If set to "yes", SYSCALL.DLL is copied in the WINDOWS directory. The
yes or no objective SYSCALL.DLL to be copied must be located in the same
directory as WINST.EXE.
UpdateVKD= If set to "yes", VKD.386 is copied in the WINDOWS directory then
yes or no registered in SYSTEM.INI. The objective VKD.386 to be copied must be
located in the same directory as WINST.EXE.
UpdatePenMouse If set to "yes", PENMOUSE.DRV is copied in the WINDOWS directory
=yes or no then registered in SYSTEM.INI. The objective PENMOUSE.DRV to be
copied must be located in the same directory as WINST.EXE.
UseKeyPad= If the application program uses the keypad library, it must be set to "yes".
yes or no If set to "yes", PADCTRL.VBX is copied in the WINDOWS directory.
The objective PADCTRL.VBX to be copied must be located in the same
directory as WINST.EXE.
UseOBR= If the application program uses the OBR library, it must be set to "yes". If set
yes or no to "yes", OBRLIB.DLL is copied in the WINDOWS directory. The objective
OBRLIB.DLL to be copied must be located in the same directory as
WINST.EXE.
UseIrDA= If the application program uses the IrDA communication library or FLINK
yes or no library, it must be set to "yes". If set to "yes", both IRDA.DLL and
IRCOMM.DRV are copied in the WINDOWS directory then registered in
SYSTEM.INI and WIN.INI. The objective IRDA.DLL and IRCOMM.DRV
to be copied must be located in the same directory as WINST.EXE.
UseYMODEM= If the application program uses the YMODEM library, it must be set to "yes"
yes or no If set to "yes", YMODEM.DLL is copied in the WINDOWS directory. The
objective YMODEM.DLL to be copied must be located in the same directory
as WINST.EXE.
UseFLINK= If the application program uses the FLINK library, it must be set to "yes". If
yes or no set to "yes", FLINK.DLL is copied in the WINDOWS directory. The objective
FLINK.DLL to be copied must be located in the same directory as WINS.EXE.
IrDA.COM2 This section is used to specify the contents to be set in WIN.INI if
UserIrDA=yes.
For information about each setup value refer to Chapter 7.9, "COM Driver
for IrDA"
Country Kind
BELGIAN
BRITISH
DANISH
FINNISH
FRENCHC
ICELANDI
LATINA
PORTUGUE
SWEDISH
SWISSG
US-DVO
287
Setting Country Kind
Brazilian
Canadian Multilingual
Dutch
French
German
Italian
Norwegian
Spanish
Swiss French
US
US-International
Setting
BRAZILIA
CANADIAN
DUTCH
FRENCH
GERMAN
ITALIAN
NORWEGIA
SPANISH
SWISSF
US
US-INT