Unassigned Parameters; Required Commreq Function Block Parameters - Emerson PACSystems RX3i User Manual
Rsti-ep dnp3 outstation module
Hide thumbs
Also See for PACSystems RX3i:
- User manual (232 pages) ,
- Application manual (37 pages) ,
- Manual (37 pages)
Table of Contents
Advertisement
User Manual
GFK-2911E
mComreq_Setup[21] := 4;
in [54])
mComreq_Setup[22] := 5;
(starting
from 1). This should be within the range provided for CROB objects. The offset starts with
0.
SN
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
The mapping below is created per the configuration above. %M6005-%M6008 become the
PLC Controlled CROB objects with associated CROB Control Dword in %R200-%R206.
6.10
Unassigned Parameters
The following COMMREQ parameters are unused.
Note:
Table 34:
Parameter
mComreq_Setup[14]
6.11
Required COMMREQ Function Block
Parameters
The callout in the ST block defines and executes the standard COMMREQ function block as
required for the configuration of the EDS001 module(s). Whenever more than one EDS001
module is installed, care must be exercised when defining parameters in the COMMREQ
Configuration of DNP3 outstation Parameters
// No of PLC Controlled CROBs (should be less than the value
// Offset of CROB to be associated with CROB Control Dword
CROB Objects
Associated CROB Control Dword
%M6001
%M6002
%M6003
%M6004
%M6005
%R200
%M6006
%R202
%M6007
%R204
%M6008
%R206
%M6009
%M6010
%M6011
%M6012
%M6013
%M6014
%M6015
%M6016
Unused parameters always have a value of zero (0).
Value
0
Chapter 6
Sep 2019
Description
Unused
56
Advertisement
Table of Contents
