Specification - Emerson PACSystems RX3i User Manual

User Manual
GFK-2911E
1.4

Specification

Specification
Module Name
Catalog
Protocol Supported
CPU Compatibility
Programmer Compatibility
Connectors
LAN
Number of IP addresses
Number of Ethernet Port Connectors
Embedded Ethernet Switch
Serial Port
Modules per RX3i CPU
No. of DNP3 Masters supported per
module
No. of DNP3 Masters supported per
RX3i CPU
No. of DNP3 points per module
No. of DNP3 events per module
Network Topology supported
RX3i Slot Location
Hot Swappable
Time Synchronization
Power Requirements
For system standards, general operating specifications, and installation requirements, refer to the
PACSystems RX3i System Manual, GFK-2314.
Introduction
Description
PACSystems RX3i DNP3 Outstation Module
IC695EDS001
DNP3 Outstation
CPU320/CPU315, CPU310/CMU310/NIU001,
CRU320/CRU320QP, CPE310 firmware version 6.0 or later
CPE302, CPE330
PAC Machine Edition 8.5 SIM7 or later
Station Manager (RS-232) Port: 9-pin female D-connector
Two 10BaseT / 100BaseTX Ports: 8-pin female shielded RJ-
45
IEEE 802.2 Logical Link Control Class I
IEEE 802.3 CSMA/CD Medium Access Control 10/100 Mbps
One
Two: both 10BaseT / 100BaseTX with auto-sensing RJ-45
connection.
Yes – Allows daisy chaining of Ethernet nodes. Ring
networks not permitted.
Station Manager Port: RS-232 DCE, 1200 - 115200 bps.
4 (max - depends on power and slots available)
8 per module (max)
32 per RX3i CPU (max)
12,072
24,000
Star, Line, Daisy Chain
Any I/O Slot in Main Rack.
Yes. Refer to Chapter 2 of the PACSystems RX3i System
Manual, GFK-2314E or later for instructions & restrictions.
SNTP Client, DNP3 Time Synchronization
3.3Vdc: 840 mA maximum
5Vdc: 614 mA maximum
Chapter 1
Sep 2019
5