Stopping Dx-D 600 - AGFA DX-D 600 User Manual

Stopping DX-D 600

To stop DX-D 600:
1. Stop NX.
NX can be stopped in two ways, either by logging out of Windows or
without logging out of Windows.
For detailed information on stopping NX, refer to the NX User Manual,
document 4420.
2. Switch off the X-Ray system using the button on the X-Ray system
electrical cabinet in the examination room.
3. Switch off the X-Ray generator control in the operator room.
The X-Ray generator and the DR Detector are powered off.
4. In a configuration with a wireless DR Detector, power off the DR Detector:
• turn off the DR Detector.
• remove the battery pack.
5. Switch off the DR Generator Sync Box.
Related Links
Starting DX-D 600
Power off behaviour
Note: Stopping the NX workstation does not stop the DR
Detector. If the power of the DR Detector remains on, no
warming-up time will be needed after starting the NX
workstation.
Note: If the DR Detector is powered down, a warming-up time
may be required on the next start-up.
on page 59
on page 56
DX-D 600 | Getting Started with DX-D 600 | 79
0240H EN 20181119 0940