Step 2: Select The Exposure - AGFA DX-D 600 User Manual

Step 2: Select the exposure

In the operator room at the NX workstation:
1. Select the thumbnail for the exposure in the Image Overview pane of the
Examination window.
The default X-Ray exposure parameters for the selected exposure are sent
to the modality and displayed on the software console.
The default X-Ray system position for the selected exposure is sent to the
modality and displayed on the software console.
2. Select the subexposure if more than one image is required for the same
cassette.
If an image thumbnail is configured for multiple exposures on a single
cassette, another set of thumbnails is shown in the image detail pane. Now
you have to select one of these thumbnails to send the proper default X-
Ray exposure parameters to the modality for each exposure.
RAD Table DR with cassette in the DR bucky
RAD Wall Stand DR with cassette in the DR bucky
Free exposure using a cassette
Note: For a bucky exposure, only cassette size 43x35 is
supported.
DX-D 600 | Getting Started with DX-D 600 | 71
0240H EN 20181119 0940