Siemens SIMATIC ET 200M Operating Instructions Manual page 269

IM 153-4 PN, 213
LEDs
IM 153-1, 181
IM 153-2, 182
IM 153-2 FO, 182
Load power supply
Properties, 51
Location of the modules, 44
M
Machinery directives, 48
Maintenance, 101
Maintenance interrupts, 217
Manual
Order Number, 249
Manufacturer ID, 192
Marine
Approval, 227
Master PROFIBUS address, 191
Maximum configuration
exceeded, 218
Module change during operation
configuration rules, 45
Module insertion interrupt, 201, 210, 211
Module removal interrupt, 201, 210, 211
Module status, 194
modules
identification with slot numbers, 67
isolated, 55, 57
Modules
number in installation setup for module change
during operation, 47
Number in the standard configuration, 44
open, 58
Mounting
of the ET 200M, 58
Mounting rail, 15
Connection of protective conductor, 62
fixing holes, 60
for active bus modules, 15, 59
for module change during operation, 59
Installing, 59
lengths, 43
N
Network
PROFIBUS DP, 12
Node flash test, 98
Number wheel, 68
ET 200M
Operating Instructions, 04/2022, EWA-4NEB7806006-09
O
Open modules, 58
Operating Instructions
Changes compared to previous manual, 4
Order number, 233
Order numbers
for accessories, 247
of the IM 153, 3
Output delay, 239
Overall configuration
in the TN-S-network, 52
P
Parameter assignment data to intelligent field devices
IM 153-2, 37
Parameter assignment telegram
See on the Internet at ..., 3, 5
Parameters
IM 153-x, 228
Pin assignment
RJ45 connector, 76
Plug adapters
for the IM 153-2 FO, 72
Order number, 248
PNO certificate, 226
Ports, 98
Power loss
Controlling, 50
Power supply, 16
Replacing, 101
Wiring, 79
Product version, 3
PROFIBUS address
setting, 68
PROFIBUS DP, 11
Network, 12
PROFIBUS module
Order number, 248
PROFIBUS standard, 226
PROFINET IO, 13
Network topology, 13
PROFINET IO Device, 96
Protection from electrical exposure, 49
Purpose of the operating instructions, 3
R
Radio interference, 48
Rail for module change during operation
Order Number, 247
Index
269