Siemens SIMATIC ET 200M Operating Instructions Manual page 244

Compatibilities between the IM 153-x
A.2 Compatibilities between the versions of IM 153-2 / -2 FO
Functions /
Update via SIMATIC Micro Memory Card
RC network with 10 MΩ for unearthed
configuration
DPV1 mode
IQ-sense
E = module version
SYNC, FREEZE should not be used for these functions.
1
not when operating with the bus module BM IM/IM 6ES7195-7HD00-0XA0
2
supports expanded diagnostics with the 96-byte diagnostic frame in the spare part scenario
3
Retrofitting
You can retrofit the IM 153-2 with order number 6ES7153-2AA02-0XB0; module version 06
to the module version 07 - this is subject to a fee.
You can retrofit the IM 153-2 FO with order number 6ES7153-2AB01-0XB0, module version
05 to module version 06 - this is subject to a fee.
Contact your Siemens representative for this.
Behavior with inserting / removing interrupt
up to
153-2AA02, module version 06
153-2AB01, module version 05
The ET 200M is set up on active bus modules. The
removal/insertion interrupt is disabled at parame-
ter assignment.
The removal or insertion of a module results in
station failure.
244
Interface module with order number 6ES7153-...
– – –
- as of x
(1 MΩ) E03
– – as of
E09
– – –
x – –
x x x
x x x
x x x
(as of
FW
V3.0.1)
as of
153-2AA02, module version 07
153-2AB01, module version 06
The ET 200M is set up on active bus modules. The
removal/insertion interrupt is disabled at parame-
ter assignment.
It is still, however, possible to remove and insert
modules. An interrupt is not reported, but the
events are displayed in the diagnosis.
Operating Instructions, 04/2022, EWA-4NEB7806006-09
– – x
x x x
– as of x
E08
– – x
(as of
FW
V3.0.1)
ET 200M