Table of Contents
Advertisement
C H A P T E R 5
A
UPS F
DDITIONAL
This section describes:
Changing the voltage configuration
The Network Transient Protector
Load segments
Voltage Configuration
The DIP switches on the UPS rear panel (see Figure 14) are used to
configure the output voltage and input voltage range.
1. The UPS must be completely shutdown.
2. Set the DIP switches according to the configurations in Table 1.
3. Plug the UPS into a power outlet.
4. Press and hold the
Powerware
5115 Rack-Mount User's Guide
®
EATURES
To turn off the UPS, press and hold the
seconds and then unplug the UPS from the power outlet.
button until you hear the UPS beep
(approximately two seconds) to turn the UPS on.
UPS Rear Panel
Figure 14. DIP Switches
164201449 Rev A www.powerware.com
button for two
ON
OFF
1
2
31
Advertisement
Table of Contents
