NEC SL2100 Programming Manual page 287

ISSUE 2.0
Item Item
No.
09 Restriction for
Common Speed
Dials
10 Restriction for
Group Speed Di-
als
11 Intercom Call Re-
striction
12 PBX Call Restric-
tion
13 Restriction of Tie
Line Calls
Conditions
None
Feature Cross Reference
None
Programming Manual
Input Data
0 = Does Not Restrict Use this option to enable/disable
1 = Following Restric- Toll Restriction for Common Speed
tion Check Dialing numbers. If enabled, System
Speed Dialing numbers have the
same restrictions as manually dialed
numbers.
0 = Does Not Restrict Use this option to enable/disable
1 = Following Restric- Toll Restriction for Group Speed Di-
tion Check aling numbers. If enabled, Group
Speed Dialing numbers have the
same restrictions as manually dialed
numbers.
0 = Disable (ICM call Determine if incoming intercom calls
not restricted.) are restricted.
1 = Enable (ICM call re-
stricted.)
0 = Disable (PBX/CTX Use this option to set how the sys-
call not restricted.) tem Toll Restricts calls over PBX
1 = Enable (PBX/CTX trunks. If you enable PBX Toll Re-
call restricted.) striction, the system begins Toll Re-
striction after the PBX access code.
The user cannot dial a PBX exten-
sion. If you disable PBX Toll Restric-
tion, the system only restricts calls
that contain the PBX access code.
The system does not restrict calls to
PBX extensions. Refer to the PBX
compatibility feature. Make sure
Program 21-05-04 (Maximum Num-
ber of Digits Table Assignment) al-
lows for PBX Toll Call Dialing (nor-
mally 12 digits).
0 = Disable (No) It chooses whether the toll restric-
1 = Enable (Yes) tion of the dial set up by 34-08 is en-
abled or disabled.
Description Default
Class 1 ~ 6 = 0
Class 7 = 1
Class 8 ~ 15 = 0
SL2100
Related
Program
0
0
Program
0
21
0 34-08
2-263