Checking The Fan Belt - Shindaiwa DG60MI Owner's And Operator's Manual

(2) Filling the Radiator
Remove the radiator plate.
1
Remove the radiator cap.
2
Fill with coolant through the filler neck until the
3
radiator is full.
Re-attach and tighten the radiator cap.
4
Attach the radiator plate.
5
< Note >
 Be sure to only use long life coolant (LLC) for the aluminum radiator. The coolant
should be mixed with good quality softened tap water, and contain anti-freezing and
anti-rust components.
 The LLC mix ratio is 30% liquid and 70% water when shipped from the factory.
(Isuzu Genuine LLC: Besco LLC Super-Type E)
 Be sure to use the same LLC in the sub-tank.
 The mix ratio should be changed according to the ambient temperature but should
remain between 30 and 50%.
 Do not increase the LLC mixture ratio unless necessary. Doing so could result in overheating
or another fault/malfunction.
 When replenishing LLC, be sure to use the same brand as the LLC remaining in the
radiator and sub-tank.
 Never use an LLC mixture of two different brands.
 Be sure to completely change every 1 years or 1,000 hours or less.
 LLC is a toxic substance. Wear rubber gloves and other protective wear when handling.
 If someone mistakenly ingests LLC, induce vomiting immediately and seek medical care.
 If LLC gets on skin or clothing, wash with water immediately.
 LLC is flammable. Store in a location where flame is prohibited and it cannot be accessed by
children.
 Engine coolant could leak if the radiator is not completely tightened or there is a gap in the
seating face. Always be sure to securely tighten the radiator cap.
 Do not add engine coolant past the FULL level line of the coolant sub-tank.
(3) Coolant Amount

8-3. Checking the Fan Belt

(1) Fan Belt Tension
Press your finger against the middle of the fan belt.
(approx. 98N) If the slack is 8-12mm, the tension is normal.
(2) Fan Belt Condition
Check the fan belt for damage and replace if any damage
or other fault is found.
(3) Fan Belt Adjustment
Loosen the alternator installation bolts, pull the alternator
1
out and adjust the fan belt tension.
Securely tighten the alternator installation bolts.
2
Check that the fan belt tension is correct.
3
Total Coolant Amount
15.4(1.5)
Value in parenthesis is the sub-tank capacity.
25
Radiator Plate
Radiator Cap
(Unit: L)
Slack
Bolt
Bolt
Filler Neck
給水口
Alternator