Troubleshooting - Shindaiwa DG60MI Owner's And Operator's Manual

Table of Contents

Advertisement

12. Troubleshooting

WARNING : ELECTRIC SHOCK/INJURY
 Do not touch output terminals or internal electric parts while the generator is
operating.
 Do not open the check door when the Power Switch is in the ON position. It
will cause injury by rotating parts such as cooling fans and fan belt.
 Always turn the Power Switch to the OFF position and stop the engine, then
close and lock OPERATION PANEL DOOR before checking or maintaining
the engine or any equipment.
CAUTION : FIRE
 Never allow flame to come close to the generator.
CAUTION : BURNS
 Do not touch the engine and surrounding components immediately after
stopping the engine as they are still extremely hot.
Inspect this generator when operation is poor to determine the fault/malfunction.
Request the authorized distributor where the generator was purchased to perform
maintenance if you cannot find any faults/malfunctions during inspection.
Problem
Starter motor
1. Battery output is weak.
does not drive
or speed is low
2. Battery is deteriorated.
3. Battery terminal is OFF or loose.
4. Battery terminal is corroded.
5. Relay is defective.
6. Starter motor is defective.
7. Controller is defective.
Starter motor
1. Fuel is insufficient.
drives but
2. Fuel filter is clogged.
engine does
3. Water is interfused in fuel line.
not start
4. Air is interfused in fuel line.
5. Poor piping connection to external fuel
6. Fuel tank selector lever (3-way valve)
7. Fuel cut solenoid (motor) does not work.
8. Fuel pump defective.
<Ambient
1. Fuel is frozen.
temperature
2. Water in fuel line is frozen.
falls down
3. Pre-heater is defective.
below zero>
Suspected cause
tank.
position is wrong.
1. Check / battery liquid/ or
2. Change battery.
3. Fix / Tighten terminal.
4. Clean terminal.
5. Ask our distributor to repair.
6. Ask our distributor to repair.
7. Ask our distributor to repair.
1. Add fuel.
2. Clean/Change fuel filter.
3. Drain water in water
4. Extract the air.
5. Check piping connection.
6. Check lever (3-way valve).
7-1. Check/Change fuse.
7-2. Check/Change fuel cut
8-1. Check/Change fuse.
8-2. Check/Change fuel pump.
1. Use winterized fuel.
2. Drain water in fuel line.
3. Ask our distributor to repair.
42
Action
Charge.
separator, fuel filter or fuel
tank.
Solenoid.

Advertisement

Table of Contents
loading

Table of Contents