Shindaiwa DG60MI Owner's And Operator's Manual page 42

(7) Draining Water from the Fuel Tank
Drain Water Every 200 hours
Set a container to catch spilled water.
1
Remove the fuel drain plug and packing (with rubber
2
seal).
After the water has been drained, reinsert the fuel
3
drain plug with new packing (with rubber seal).
< Note >
 Replace the packing of the fuel drain plug with new packing each time the water is drained.
 Packing part no.: V106-000110
 After reinserting the fuel drain plug, be sure to always check that there is no fuel leakage.
(8) Coolant Replacement
Replace
Set a container to catch spilled coolant.
1
Remove the radiator plate.
2
Remove the radiator cap.
3
Loosen the drain cock of the radiator and
4
the drain plug of the engine.
After the coolant has been drained, reinsert
5
the coolant drain plug with new packing.
Remove the subtank and flush the coolant
6
from the subtank.
Reattach the subtank to its original position
7
and fill with coolant until it reaches the
FULL level.
Fill the radiator with coolant until it reaches
8
the filler neck.
Re-attach and tighten the radiator cap.
9
Attach the radiator plate.
10
< Note >
 Refer to section "8-2. Checking Coolant" for coolant
information.
 After reinserting the coolant drain plug and shortly after
starting the engine, be sure to always check that there is
no coolant leakage.
Every year or Every 1000 hours
Drain Cock
(Radiator)
Sub Tank
FULL
(Radiat
LOW
or)
(Radiat
or)
39
Fuel Drain Plug
With Rubber Seal
Radiator Plate
Filler Neck
給水口
Radiator Cap
Drain Plug
(Engine)
Coolant Drain Hose