Checking The Fan Belt; Checking The Fuel; Checking The Spill Containment - Shindaiwa DG50MK-P Owner's And Operator's Manual

Diesel engine generator
Table of Contents

Advertisement

8-3. Checking the Fan Belt

(1) Fan Belt Tension
Press your finger against the middle of the fan belt.
(approx. 98N) If the slack is 7 to 9 mm, the tension is normal.
(2) Fan Belt Condition
Check the fan belt for damage and replace if any damage
or other fault is found.
(3) Fan Belt Adjustment
Loosen the alternator installation bolts, pull the
1
alternator out and adjust the fan belt tension.
Securely tighten the alternator installation bolts.
2
Check that the fan belt tension is correct.
3
Attach the fan guard.
4
(4) Replacing the Fan Belt
Request the authorized distributor where the generator
was purchased to replace the fan elt.
< Note >
Use of a loose or damaged fan belt could result in overheating or insufficient charging.
Do not operate the generator if fan guard has been removed.

8-4. Checking the Fuel

CAUTION : FIRE
This generator uses diesel fuel. Always be sure to stop the engine and not
bring flames close when inspecting fuel or refueling. Wait until the engine has
cooled before performing such procedures.
If fuel spills, always be sure to open the spill containment drain valve and
drain off the spilled fuel.
(Refer to section "10. Inspection/Maintenance (8) Flushing Liquid in Spill
Containment".)
Check if there is a sufficient amount of fuel and add fuel if
insufficient. The fuel meter on the control panel will only
display the fuel level for the internal fuel tank.
< Note >
Use Diesel fuel, ASTM D975 No.2-D in the event ambient
temperature reaches down to –5 degree Celsius.
Always use the Diesel Fuel Strainer.
Fill the fuel tank slightly less than the FULL tank level.
Fuel requirements:

8-5. Checking the Spill Containment

CAUTION : FIRE
If fuel or oil is leaking, repair the leaking location before operating.
Open the check door and check the inside of the spill containment. Flush out any
accumulated liquid. Refer to section "10. Inspection/Maintenance (8) Flushing Liquid in
Spill Containment" for flushing procedures.
Slac
Bolt
Bolt
Alternator
Fuel Strainer
Fuel
Tank Cap
Fuel Cover

Advertisement

Table of Contents
loading

Table of Contents