BMW M5 Owner's Handbook Manual page 316

MOBILITY
Removing and storing the sealant
container
1. Unscrew the filler hose of the sealant con‐
tainer from the tyre valve.
2. Press the red unlocking device.
3. Remove the sealant container from the com‐
pressor.
4. Pack and store the sealant container to avoid
soiling the boot.
Minimum tyre inflation pressure is
not reached
1. Unplug the connector from the socket in the
vehicle interior.
2. Drive forwards and backwards by 10 m, ap‐
proximately 400 inches, to distribute the seal‐
ant in the tyre.
3. Screw the connecting hose of the compres‐
sor directly onto the tyre valve.
4. Insert the plug into the socket in the vehicle
interior.
5. Switch on the compressor with standby state
switched on or the engine running.
316
Wheels and tyres
Online Edition for Part no. 01402989787 - II/18
If the tyre inflation pressure of at least 2 bar is
not reached, contact a Service Partner of the
manufacturer or a qualified Service Partner or
a specialist workshop.
If the tyre inflation pressure of at least 2 bar is
reached, see Minimum inflation pressure is
reached.
6. Unscrew the connecting hose of the com‐
pressor from the tyre valve.
7. Unplug the connector from the socket in the
vehicle interior.
8. Store Mobility System in the vehicle.
Minimum tyre inflation pressure is
reached
1. Unscrew the connecting hose of the com‐
pressor from the tyre valve.
2. Unplug the connector from the socket in the
vehicle interior.
3. Store Mobility System in the vehicle.
4. Immediately drive for approximately
10 km/5 mi to evenly distribute the sealing
compound in the tyre.
Do not exceed a speed of 80 km/h/50 mph.
If possible, do not drive slower than
20 km/h/12 mph.
To adjust
1. Stop in a suitable area.
2. Screw the connecting hose of the compres‐
sor directly onto the tyre valve.