Advertisement
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
Perform the following procedure to prepare the mower
for attaching the blower and finishing kit.
Description
No parts required
Double pulley assembly
No parts required
Blower hinge
Metal template
Bolt (3/8 x 1 inch)
Locknut (3/8 inch)
Blower belt
Spring
Blower assembly
Belt cover
Bolt (1/2 x 2-1/2 inches)
Nut (1/2 inch)
Front guard
Back guard
Bolt (1/4 x 5/8 inch)
Nut (1/4 inch)
Latch bracket assembly
Bolt (3/8 x 2-1/2 inches)
Nut (3/8 inch)
Latch bracket strap
Screw (#10 x 1/2 inch)
Nut (#10)
Belt cover bracket
Carriage bolt (1/4 x 3/4 inch)
Locknut (1/4 inch)
Throttle stop
Qty.
–
Prepare the machine.
1
Install the pulley assembly.
Remove the existing anti-scalp roller
–
and bracket (for 60-inch decks only).
1
1
Install the blower hinge.
3 or 4
3 or 4
1
Route the blower belt into the blower
assembly.
1
1
Install the blower assembly.
1
1
Install the belt cover and bolt.
1
1
1
Install the blower guards.
6
1
1
2
2
Install the tube latch.
1
2
2
1
Install the new belt cover bracket upon
2
removal of the kit (for model 31212
only).
2
1
Install the throttle stop.
1.
Park the machine on a level surface, disengage
the PTO, move the motion-control levers to the
N
-
EUTRAL
LOCK
brake.
2.
Turn the key switch to the O
the key, and wait for all movement to stop before
leaving the operating position.
3.
Repair all bent or damaged areas on the mower
deck and replace any missing parts.
4.
Clean any debris off the deck or rear part of the
mower to ease installation.
2
Use
position, and engage the parking
position, remove
FF
Advertisement
