Advertisement
3
Removing the Existing
Anti-Scalp Roller and
Bracket
(For 60-inch Decks Only)
No Parts Required
Procedure
1.
Clean the area around the right, rear anti-scalp
wheel.
2.
Remove the anti-scalp roller from the bracket
by loosening and removing the flange nut (3/8
inch) and axle bolt (3/8 x 4-1/2 inch) as shown
in
Figure
3.
3.
Remove the 3 carriage bolts (3/8 x 3/4 inch) and
flange nuts (3/8 inch) securing the bracket to the
mower
(Figure
3).
Note:
Save all hardware for later use.
1. Anti-scalp roller
2. Anti-scalp bracket
3. Bolt (3/8 x 4-1/2 inch)
Figure 3
4. Carriage bolt (3/8 x 3/4
inch)
5. Flange nut (3/8 inch)
6. Mower deck
4
Installing the Blower Hinge
Parts needed for this procedure:
1
Blower hinge
1
Metal template
3 or 4
Bolt (3/8 x 1 inch)
3 or 4
Locknut (3/8 inch)
Procedure
Model 31212
1.
Install the metal template to the mower deck
with the previously removed carriage bolts and
nuts using the existing holes in the mower deck
(Figure
4).
Note:
Make sure that the carriage bolts and
nuts are tight and that the template is tight
against the mower deck.
2.
Center punch the new mower deck hole
locations using the 4 holes in the template
(Figure
4).
3.
Remove the metal template and drill 4 pilot holes
(1/8 inch) with a sharp drill bit
4.
Drill 4 holes (13/32 inch) into the pilot holes with
a sharp drill bit
g003313
4
(Figure
4).
(Figure
4).
Advertisement
