Advertisement
7
Installing the Belt Cover
and Bolt
Parts needed for this procedure:
1
Belt cover
1
Bolt (1/2 x 2-1/2 inches)
1
Nut (1/2 inch)
Procedure
1.
Lower the mower deck to the lowest height-of-cut
position.
2.
Install the new belt cover so the notches on both
sides go over the belt cover supports
15
and
Figure
16).
Figure 15
Model 31212
1. Belt cover
2. Hairpin assembly
(Figure
g034077
3. Nut
1. Knob
2. Belt cover
3.
Lower the mower deck and install a bolt (1/2 x
2-1/2 inches) and nut (1/2 inch) into the 152 mm
(6 inch) height-of-cut hole
Note:
This prevents damage to the double
pulley when raising the mower deck up.
1. 152 mm (6 inch)
height-of-cut hole
2. Nut (1/2 inch)
9
Figure 16
Model 31213
3. Mower deck
(Figure
17).
Figure 17
3. Bolt (1/2 x 2-1/2 inches)
g011051
g011183
Advertisement
