Advertisement
Figure 22
1. Locknut (1/4 inch)
2. Drilled hole
11
Installing the Throttle Stop
For CE Compliant GM7200 or
GM7210 International Machines
with Kubota Engines
Parts needed for this procedure:
1
Throttle stop
Procedure
Note:
This procedure is only for CE compliant
GM7200 or GM7210 international machines with a
Kubota
®
engine.
1.
Remove the nut and washer securing the speed
control lever to the governor shaft
g033987
3. New belt cover bracket
4. Carriage bolt (1/4 x 3/4
inch)
(Figure
23).
1. Throttle stop
2. Nut and washer
2.
Insert the throttle stop onto the governor shaft so
the tab rests against the flat on the speed-control
lever
(Figure
23).
3.
Install the washer and nut onto the shaft and
torque to 9.7 to 12.0 N∙m (86 to 106 ft-lb).
12
Figure 23
3. Speed-control lever
g012500
Advertisement
