Advertisement
Figure 7
1. Mower deck
4. Bolt (3/8 x 4-1/2
inch)
2. Bolt (3/8 x 1
5. Spacer
inch)
3. Locknut (3/8
6. Anti-scalp roller 9. Drilled holes
inch)
Routing the Blower Belt
into the Blower Assembly
Parts needed for this procedure:
Procedure
g011056
1.
7. Bushing
8. Blower hinge
assembly
1. Existing bracket
2.
3.
6
5
1
Blower belt
1
Spring
If present, cut the existing belt cover bracket
so that it is flush with the edge of the top deck
assembly; refer to
Figure
Note:
Remove any sharp edges.
Note:
Upon removal of this kit, install the new
cover bracket; refer to
Cover Bracket Upon Removal of the Kit (page
11).
Figure 8
Install the belt around the blower pulley
9).
Install the spring to the idler arm and the peg on
the blower assembly
8.
10 Installing the New Belt
2. Edge of top deck assembly
(cut existing bracket flush
with this)
(Figure
(Figure
9).
g033986
Advertisement
