Voice Synthesizer Installation; Tone Unit Installation - Kenwood TS-450S Instruction Manual
Hf transceiver, all mode multi bander
Hide thumbs
Also See for TS-450S:
- Service manual (184 pages) ,
- Instruction manual (99 pages) ,
- Service manual (184 pages)
Table of Contents
Advertisement
82
7-2.
VS-2 VOICE SYNTHESIZER INSTALLATION
7-3.
TU-8 TONE UNIT INSTALLATION
burst
Remove —>
the backing
LINN
SNOL
NOILdO
]
]
Continuous
IF UNIT
Front Panel
'
= 7
ih:
2.
na
=
N
o
Remove the top cover of the transceiver.(Fig.1)
Remove the speaker fitting.(Fig.2)
Use the three screws supplied with the VS-2 to install
the VS-2 on the chassis.
Caution
Keep the pan-head screw and cushion provided
with the VS-2 for later use. They are not needed
now.
. Plug the 8-pin connector into the VS-2 socket.
©
CAR UNIT
Fig. 3
Reinstall the speaker and the top case of the
transceiver.
. Remove the bottom case of the transceiver.
Plug the connector with lead from W3 into the TU-8
socket.
Remove the backing from the double-sided adhesive
tape on the rear of the TU-8.
. Attach the TU-8 to the specified location.
Make sure that the TU-8 switch is set to the
continuous tone or tone burst and select the required
tone frequency.
. Reinstall the bottom case of the transceiver.
Advertisement
Table of Contents
