Narrow Band Fm Operation; Power-On Message - Kenwood TM-481A Instruction Manual

NARROW BAND FM OPERATION

By default, the transceiver operates in normal FM
(±5 kHz) mode for both transmission and reception.
You can also operate the transceiver in narrow band FM
(±2.5 kHz).
To operate the transceiver in narrow band FM:
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 26 (FMN).
2 Press [MENU] and turn the Tuning control to select
"ON" or "OFF" (default).
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.
When narrow band FM operation is ON, "N" appears in
the top right of the LCD.
11
Note: You can store the narrow band FM operation status to the
Memory Channels {page 29}.
58

POWER-ON MESSAGE

You can change the Power-on message (a maximum of
6 characters) when the transceiver is turned ON.
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 23 (P.ON.MSG).
2 Press [MENU].
• The current message and entry cursor appear.
3 Turn the Tuning control to select a character.
• You can enter the following alphanumeric characters:
0 ~ 9, A ~ Z, – (hyphen), / (slash), and a space.
• Rather than using the Tuning control, you can use the
Mic keypad (keypad models only) to enter alphanumeric
characters {page 62}.
4 Press [MR] to move to the next digit.
• To move to the previous digit, press [VFO]. To delete the
character at the current cursor position, press [F].
5 Repeat steps 3 and 4 to enter up to 6 digits.