Raytheon 133-560 Series Operator's Manual page 38

4.2.2 Measures in case of alarms on the Repeater Compass
The possible alarms of the Repeater Compass are indicated as error codes on the digital
display of the Repeater Compass.
Error code
No or false
indication.
(
(Course bus and
"G_AL")
Edition: July 06, 2005
Error type
Fault of the electronic.
Serial interface defective
(red)
or
transmitted telegram invalid. transmitted telegram invalid
No data transmitted.
(red)
)
Operator manual
Possible cause
PCB of the Repeater Com-
pass is disturbed or
defective.
-- Heading sensor
transmitts no or invalid
data.
-- False configuration of
the Repeater Compass
-- Repeater Compass
defective
-- Cable defective
-- False configuration
-- System compass
(gyro or magnetic)
defective
-- Serial interface
disconnected
34
Measures
-- Switching off and on the
power supply (Restart)
-- if necessary exchange
Repeater Compass
-- Check the heading
source sensor
-- Configure Repeater
Compass
-- Restart repeater
-- Exchange Repeater
Compass
-- Confirm alarm by op--
erating the left or right
key
-- LED flashes red
-- Check cable connec--
tions
-- Confirm alarm by op--
erating the left or right
key
-- LED flashes red
-- Configure Repeater
Compass again
-- Restart repeater
-- Confirm alarm by op--
erating the left or right
key
-- LED flashes red
-- Check system compass
-- Confirm alarm by op--
erating the left or right
key
-- LED flashes red
-- Connect serial interface
3649.DOC010102