Switching On The Repeater Compass - Raytheon 133-560 Series Operator's Manual

2.3

Switching on the Repeater Compass

When the supply voltage is switched on, the Repeater Compass is put into operation. After
switching on the Repeater Compass an automatical synchronisation follows.
The current heading is shown by the analog and digital indications.
The digital display alternates between the current heading indication and the current type of
the heading sensor every 30 seconds. The heading sensor is indicated by a flashing display
for approx. 5 seconds.
If the Repeater Compass is switched on and there is no interface connected, the messages
below are indicated:
In this case the measures described in section 4.2.2 are required.
3649.DOC010102
Operator manual
Indications
(red)
(red)
Comments, notes
-- LED lights up red
-- The display indicates "
-- The cards adjust to 0°
-- The display indicates "
-- After approx. 10s the display indicates "Con" flashing
(refer to section 4.2.2)
-- The LED flashes red
Optional:
Audible alarm signal (buzzer)
-- confirm by operating the left or right key
(Only if the Repeater Compass is used as steering repeater.)
11
REPEATER
133--560
"
"
Edition: July 06, 2005