Electrical Installation Of The Repeater Compass; First Putting Into Operation - Raytheon 133-560 Series Operator's Manual

3.1.2

Electrical installation of the Repeater Compass

The supply cable of the Repeater Compass that has to be connected to the ships mains and the
heading interface is already connected to the terminal strip inside the repeater. It is fixed in the
cable entry of the repeaters casing.
Connect the supply cable to any serial NMEA interface as shown in Fig. 4:
Fig. 4: Cable connection of the Repeater Compass
The brown and black cord is covered with a green/yellow tube.
3.2

First putting into operation

-- Switch on the Repeater Compass as described in section 2.3.
-- The Repeater Compass recognizes the course bus interface and adjusts to it automatically.
-- For NMEA operation the Repeater Compass has to be configurated.
The operation mode ("G_AL", "G_M_", "G_--_", "M_--_") and the corresponding types of
telegrams have to be adjusted (refer to section 3.3).
Edition: July 06, 2005
Operator manual
pink
grey
green
yellow
brown
(green/
yellow)
black
24
1
TX+
RS232
2
TX--
3
+24V DC
4
0V
5
6
TX--
RS422
TX+
3649.DOC010102