Integra DTR-6.8 Instruction Manual page 92

DTR-6.8_En.book Page 92 Wednesday, June 20, 2007 4:16 PM
Advanced Setup—Continued
Speaker Level Calibration
This setting is set automatically by the Automatic
Speaker Setup function (see page 52).
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
Notes:
• The speakers cannot be calibrated while the output of
the AV receiver is muted.
• The test tone is output at the standard level for THX,
which is 0 dB (absolute volume setting 82). If you nor-
mally listen at volume settings below this, be careful
because the test tone will be much louder.
2, 3
1, 6
1 Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [Enter].
The Speaker Setup menu appears.
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
92
3
4
1
2-5
5
]/[ ]
6
Notes:
• This procedure can also be performed by using the [Test
Tone] button, [Level–] and [Level+] buttons. First press
the [Test Tone] button to output the test tone. Use the
[Level–] and [Level+] buttons to set the volume, and use
the [CH Sel] button to select the speakers.
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
Use the Up and Down [ ]/[
buttons to select "4. Level Cali-
bration," and then press [Enter].
The Level Calibration menu appears
and the pink noise test tone is output by
the front left speaker.
2–4. Level Calibration
Left 0dB
Center 0dB
Right 0dB
Surr Right 0dB
Surr Back R 0dB
Surr Back L 0dB
Surr Left 0dB
Subwoofer 0dB
Note:
Speakers that you set to No or None on
the Speaker Configuration page
(page 88) cannot be selected.
Use the Up and Down [ ]/[
buttons to select each speaker,
and use the Left and Right [
[ ] buttons to set the volume.
The volume can be adjusted from –12
to +12 dB (–15 dB to +12 dB for the
subwoofer) in 1 dB steps.
Repeat step 4 until the volume of
the test tone from each speaker
is the same.
If you're using a handheld sound level
meter, adjust the level of each speaker
so that it reads 75 dB SPL at the listen-
ing position, measured with C-weight-
ing and slow reading.
Press the [Setup] button.
The setup menu closes.
]
]
]/