Learning Commands - Integra DTR-6.8 Instruction Manual

DTR-6.8_En.book Page 119 Wednesday, June 20, 2007 4:16 PM
Controlling Other Components—Continued

Learning Commands

The AV receiver's remote controller can learn the com-
mands of other remote controllers. By transmitting, for
example, the Play command from your CD player's
remote controller, the remote controller can learn it, and
then transmit the exact same command when its Play
[ ] button is pressed in the CD remote mode.
This is useful when you've entered the appropriate
remote control code (page 116) but some buttons don't
work as expected.
1
1,4
1
While holding down the Remote
Mode button for the mode in
which you want to use the com-
mand, press the [On] button.
The Remote indicator lights up.
2
Press the button you want to
learn the new command.
3
Remote
indicator
4
Notes:
• The following buttons cannot learn new commands:
Remote Mode, Macro [1], [2], [3], TV [
[Input], TV CH [+]/[–], TV VOL [
• The remote controller can learn approximately 70 to
90 commands, although this will be less if commands
that use a lot of memory are learned.
• Remote controller buttons such as Play, Stop, Pause,
and so on are preprogrammed with commands for
controlling Integra CD players, cassette decks, and
DVD players. However, they can learn new com-
mands, and you can restore the preprogrammed com-
mands at any time by resetting the remote controller
(see page 117).
• To overwrite a previously learned command, repeat
this procedure.
• Only commands from infrared remote controllers can
be learned.
• When the remote controller's batteries expire, all
learned commands will be lost and will have to be
learned all over again, so don't discard your other
remote controllers.
Point the remote controllers at
each other, about 2 to 6 inches
(5–15 cm) apart, and then press
and hold the button whose com-
mand you want to learn until the
Remote indicator flashes.
If the command is learned successfully,
the Remote indicator flashes twice.
About 2 to 6
inches (5–15 cm)
RC-694M
To learn more commands, repeat
steps 2 and 3.
Press any Remote Mode button when
you've finished.
], TV
]/[ ], Light.
119