Connecting A Cd Player Or Turntable - Integra DTR-6.8 Instruction Manual

DTR-6.8_En.book Page 37 Wednesday, June 20, 2007 4:16 PM
Connecting the AV Receiver—Continued

Connecting a CD Player or Turntable

■ CD Player or Turntable (MM) with Built-in Phono Preamp
Step 1:
Choose a connection that matches your CD player ( ,
phono preamp.
b
Connect one or
c
the other
Connection b
must be
assigned (see
page 49)
COAXIAL
OUT
• With connection , you can listen to and record audio from the CD player and listen in Zone 2.
a
• To connect the CD player digitally, use connection
Connection
a
DIGITAL COAXIAL IN 2 (VCR/DVR)
b
DIGITAL OPTICAL IN 2 (CD)
c
■ Turntable (MM) with no Phono Preamp Built-in
The AV receiver's PHONO IN is designed for use with a
moving magnet (MM) type cartridge.
Use an analog audio cable to connect the AV receiver's
PHONO IN L/R jacks to the audio output on your turn-
table.
Notes:
• If your turntable has a ground wire, connect it to the
AV receiver's GND screw. With some turntables, con-
necting the ground wire may produce an audible hum.
If this happens, disconnect it.
• If your turntable has a moving coil (MC) type car-
tridge, you'll need a commercially available MC head
amp or MC transformer. Connect your turntable to the
head amp or transformer, and connect that to the AV
receiver's PHONO IN L/R jacks.
• You can also use a phono equalizer to connect a turn-
table with an MC-type cartridge. See your phono
equalizer's manual for details.
, or
a b
IN 2
(VCR/DVR)
COAXIAL
OPTICAL
IN 2
(CD)
IN
L
R
CD
a
L R
OPTICAL AUDIO
OUT OUT
b
AV receiver Signal flow
CD IN L/R
). Use connection for a turntable with a built-in
c a
L
R
CD
a
CD player
or . (For recording, use and
c a
CD or turntable
⇐
Analog audio L/R output
⇐
Digital coaxial output
⇐
Digital optical output
L
R
IN
PHONO
AUDIO
OUTPUT
L
R
IN
L
R
AUDIO
OUTPUT
Turntable (MM) with
built-in phono preamp
, or and .)
b a c
37