Integra DTR-6.8 Instruction Manual page 54

DTR-6.8_En.book Page 54 Wednesday, June 20, 2007 4:16 PM
First Time Setup—Continued
7 After the 3rd to the 7th measure-
ment, the following screen
appears.
Please select "Next" , when measuring
next position, and select "finish" ,
when ending.
Next
finish (Calculate)
Use the Up and Down [
buttons to select an option, and
then press [Enter].
Next: Select this if you want to mea-
finish (Calculate): Select this if you
8
When the measurements are
complete, the following screen
appears.
9
When the calculations are com-
plete, the following screen
appears.
Save
Review SP Config
Review SP Distance
Review SP Level
Cancel
54
Auto Speaker Setup
AUDYSSEY
]/[ ]
sure another listening posi-
tion.
After the 8th measurement
has been taken, the procedure
automatically proceeds to
step 8.
don't want to measure any
more listening positions and
are ready to calculate the
results, then go to step 8.
Auto Speaker Setup
AUDYSSEY
Calculating...
Auto Speaker Setup
AUDYSSEY
Use the Up and Down [
buttons to select an option, and
then press [Enter].
The options are:
Save:
Save the calculated settings and exit
the automatic speaker setup.
Review SP Config:
Review the speaker configuration
settings (see "Reviewing the
Results" on page 56).
Review SP Distance:
Review the speaker distance set-
tings (see "Reviewing the Results"
on page 56).
Review SP Level:
Review the speaker level settings
(see "Reviewing the Results" on
page 56).
Cancel:
Cancel the automatic speaker setup.
10 If you selected "Save," the results are
saved, and the following screen
appears.
Auto Speaker Setup
11 Disconnect the speaker setup
microphone.
Auto Speaker Setup
Please unplug microphone.
Notes:
• When the automatic speaker setup is complete, the
Equalizer Settings (page 93) will be set to "Audyssey."
• You can cancel the automatic speaker setup at any
point in this procedure simply by disconnecting the
setup microphone.
]/[ ]
AUDYSSEY
Saving...
AUDYSSEY