Installing Additional Memory - Xerox DocuPrint 3055 Quick Reference Manual

Installing Additional Memory

In case of the following situations, install additional memory to the printer.
• When [Print Page Mode] is set to [On] on your print driver
Setting [Print Page Mode] to [On] changes the printing method of the printer. When printing large data,
or when the printer is taking too much time to print, set [Print Page Mode] to [On] and try printing again.
• When the [Out of memory] message appears frequently on the control panel
• When installing the optional PostScript software kit (recommended)
Additional memory may also be required depending on the [Print Mode] setting on the print driver and the
paper size to be printed.
The following table lists the required memory capacity.
Print
Mode
Standard
PCL
(297 x 900 mm)
print driver
HIgh
Quality
• Output possible
• Recommended capacity:Memory capacity recommended by Fuji Xerox.
Values of the required memory capacity also vary depending on the usage environment of the printer.
Note
• When using long paper, 2-sided printing and the printing in the [High Quality] print mode are not available.
• For more information about additional memory and how to order it, refer to "Optional Accessories" (P. 69).
1 Sided Print
Paper Size
Output
Possible
A5
B4
A4 Standard
(64 MB)
8.5 x 14"
Long paper
A5
Standard
B5
(64 MB)
A4
8.5 x 14"
:Most data can be printed. However, some data may not be printed depending
on the type of print data, or the print speed may decrease when 2-sided printing
is performed.
Recommended Output
Capacity Possible
Standard
(64 MB)
Standard
(64 MB)
-
Standard
(64 MB)
Standard
320 MB
(64 MB)
(Standard +
256 MB)
Installing Additional Memory
2 Sided Print
Recommended
Capacity
Standard
(64 MB)
-
Standard
(64 MB)
320 MB
(Standard +
256 MB)
71
IE
IE