Preparation Before Operation - Mitsubishi Electric MSZ-AH09VA-H1 Operating And Installing Instructions

Preparation Before Operation

Please contact your dealer to install the air conditioner.
Select mounting location(please do it before installing
the batteries)
According to the actual mounting location of the indoor unit,set the
location to mount the remote controller accordingly.
Calculate the
mounting location
Please confirm the mounting
location of the indoor unit in
the room.
Remote controller
setting
Remove the back lid of the
controller and set it based on
the mounting location of the
indoor unit.
Display on the
remote controller
Changes are displayed in
the form of menus.
If the mounting location is selected incorrectly,it will cause poor cooling
or heating effect.
When the air conditioner is mounted at the left or right side and stops
running,the Human Sense MOVE EYE will turn to the center of the room.
Left
How to set time
1
Remove the back lid of
the remote controller
and insert the batteries.
According to
the direction
of arrow mark
open the back
cover.
Insert the negative pole of the
batteries first and check if the
polarity is correct.
After the time is set,the button
light on,the setting is finished.
If the time fails to be set within 30s,the time setting function will be released.
Press the button and each function setting will restore to the ex-work setting.
复位
6
Left Center
Installed at the left side Installed in
the center
(The distance is not
more than 50cm)
(Left) (Center) (Right)
If the indoor unit is installed more than 50cm away from
the side walls or cabinets or other nearby object,the
switch shall be set in the center.
Left
Center Right
2 3
Open the front lid
and press the
复位
button.
Press using a thin stick. Press using a thin stick.
Flickering
时间
must be pressed.When the flickering of the time setting content changes to be
How to use the remote controller
Send signal to the signal receiving
section of the remote controller of the
indoor unit.
Right
Installed at the right side
(within a distance of
50cm as required)
Right
Center
<Reference for replacing batteries>
4
Press the
Press the
时间设定
button.
to adjust the time.
The 24-hour system
is used.
Flickering
时间
时间
The range that the signal can reach is about
7m when the remote controller is pointed at the
front of the indoor unit.
Be sure not to place any articles which will
block the signal transfer between the remote
controller and the indoor unit.
Be sure not to place the remote controller at
places directly exposed to sunlight or near stoves.
No signal,no display and dim display(refer to
page 27).
When the remote controller needs
hanging on the wall,pull out the
installation hook from the back of
the remote controller and hang it on
the wall.
If the batteries of the remote controller almost
run out,the indoor unit will not respond to
the remote control signal and the display
will becomes dim.At this time,please replace
them with 2 new no.7 alkaline batteries (LR03)
(whose life span is about 1 year).
Be sure not to use batteries of different types
or mix the new one with the old one.
Be sure not use rechargeable batteries
or manganese batteries.This may cause
malfunction.
Be sure not to place them at the place where
kids can reach,to avoid the risk of eating by
mistake.
5
button Press the
button.
Flickering
时间