Airflow Velocity·direction Adjustment - Mitsubishi Electric MSZ-AH09VA-H1 Operating And Installing Instructions

Airflow Velocity·Direction Adjustment
Set the airflow velocity and direction until you feel comfortable.
<Open the lid>
When the airflow velocity and the horizontal air direction are switched to 「 Auto 」 and the vertical air direction
to ,the unit will beep.
When the horizontal air direction and the vertical air direction are adjusted,the function of Indirect
flow · Direct flow · Circulation will be canceled.
If long distance air supply is set for the airflow velocity,there will be the maximum velocity.
Caution
During operation,don't use your hand to turn the vanes for horizontal airflow as well as the vertical airflow,
or trouble will occur.
10
How to adjust airflow velocity
Press the
Each time the button is pressed,the airflow velocity is changed in the following sequence
Auto
Static
(Low)
Select「Long distance」mode to increase the airflow velocity.If you want
the air to blow further,this function can be selected.
Horizontal air direction adjustment
Press the
Each time the button is pressed,the airflow direction is changed in the following
sequence.
AUTO
AUTO
(swing)
(swing)
※To achieve comfortable airflow direction
control,this air conditioner uses the two-
segment upper and lower vaneshorizontal
vane,which are respectively controlled
by independent stepping motors.
Therefore,though the same air supply
locations are set for the upper and lower
vaneshorizontal vane,there still will be
small difference between the upper and
lower vanes in actual operation.
Vertical air direction adjustment
Press the
Each time the button is pressed,the airflow direction
is changed in the sequence on the right chart.
Between the Cooling (Drying) and Heating modes,
the angle may be of slight difference.
button
Long distance
(Mediu) (High)
buttons
In Cooling·Drying mode,the air blows horizontally;
AUTO
in Heating mode,it blows downward.
Please make choice according to your
feeling of comfort.
The angle displayed on the remote
controller is different from the
actual angle of the horizontal vane.
In the Cooling·Drying mode,the
air can't blow downward for long so
as to prevent water from dropping.
The airflow direction may change
automatically.
Every certain interval,the horizontal vane will swing
automatically.When they swing to the upper and
(swing)
lower limits,they will stay there for a short time.
<Range of the horizontal vane in swing mode>
Airflow velocity setting Cooling · Drying
Settings other than
long distance air supply
When the long distance
air supply is set
button
.
The actual acting range
of the vertical vane
Acting range
Cooling
Drying
Heating
Heating
(swing)