Time Set Timer - Mitsubishi Electric MSZ-AH09VA-H1 Operating And Installing Instructions

Time Set Timer

It can set the ON/OFF-Timer of the air conditioner at the same time with a time scale
of 10 minutes.
The set timer is only for once operation,so it shall be reset each time of use.
Please set against the current time.If the current time is not set,you can't use Time Set ON/OFF-Timer.
ON-Timer can also be set in the shutdown status.
<Open the lid>
When the timer is set,please put the remote controller where the remote control signal can reach the indoor
unit.When the set time is reached,even if the signal from the remote controller can't reach the indoor unit,the
timing function will operate.However,the operating time may deviate from the set time.
When the ON-Timer is set,"
even the unit is stopping.The set content for the operation will be displayed inside the controller.
In the case that the「 」or「 」is flickering,the set time will be released if no operation is carried out within
about 30 seconds.
In operation,press the
1
Press the button,adjust to the appointed time
2
Switch it on a 10-minute scale.Press the button and hold it to realize fast
switching.
Press the
3
The indoor unit will beep.
「 」or「 」will light on,and the setting is finished.
When ON-Timer and OFF-Timer are used at the same time,repeat the
operation in the sequence
To change the set time,follow the sequence
If the ON-Timer is set in operation,the unit will stop running after the
setting is finished.
<Example of setting the ON-Timer and OFF-Timer at the same time>
For instance:the current time:22∶00,23∶00 Off→the next morning 6∶00 On
1
Press the button,press the
desired time and then press the
2
Press the button,press the
desired time and press the
When the temperature and humidity are to be set,please
first press the
To release
Press the
When you want to cancel one between the ON-Timer and OFF-Timer,please
press the button for the timer you want to cancel.Then press the
button.
Press the button,the set timer will be canceled and all operation will
be stopped.
" will be displayed on the I FEEL temperature display section of the indoor unit
or
button
→ → .
2
3
button to adjust to the
button
button to adjust to the
button
The timer that reaches the set time first will operate first.
Indicating the operation sequence of the timer.
button and then set them.
button
button
→ → .
2 3
15